CompuSTAR 1W900SHR-961 Manual de instalación descargar pdf (Pagina 5)

Remote Programming Routine

IMPORTANT: Any and all remotes must be coded to the control module prior to performing any and all

operations.

Remotes excluding P2WSSR

STEP 1: Activate programming mode by manually turning the vehicle’s key between the Ign On and Off

(or the Acc & On positions) five times within 7 seconds. The vehicle’s parking lights will flash once with

the successful completion of this step. (Note: this step also places the control module into Valet Mode)

STEP 2: Within a 2 second period after the 5

ignition cycle tap Button I on two way remotes or the

Lock button on one-way remotes for 0.5 seconds. The parking lights will flash once to confirm the

transmitter has been coded. Repeat for additional remotes, up to three.

Exiting Programming: Programming is a timed sequence. After 2

seconds the parking lights will flash twice signaling the end of

programming mode.

Programming Multiple Remotes: After the confirmation flash given in

STEP 2, code additional remotes by tapping Button I on two way

remotes or the Lock button on one way remotes. The parking lights

will flash once confirming each additional remote. All systems (except

the P2WSSR), can recognize up to three remotes.

Note: If you program only 1 Way remotes to a 2 Way antenna you will

receive 3 parking light flashes and/or siren chirps when you turn the

ignition on. This will be alleviated by programming a 2 Way remote.

Pro P2WSSR

STEP 1: Remove the AA battery from the remote.

STEP 2: Activate programming mode by manually turning the vehicle’s key between the Ign On and Off

(or the Acc & On positions) five times within 7 seconds. The vehicle’s parking lights will flash once with

the successful completion of this step. (Note: this step also places the control module into Valet Mode)

STEP 3: Within a 2 second period after the 5

ignition cycle, insert the AA battery into the remote. The

parking lights will flash once to confirm this step. If you have an additional 1 Way remote tap the Lock

button after inserting the AA battery into the 2 Way remote.

STEP 4: Wait several seconds for the parking lights to flash twice and the remote LCD to receive a page

back. The transmitter has now been coded.

Programming Multiple Remotes: After the confirmation flash given in step 3, program the optional 1

Way remote by tapping the Lock button for 0.5 seconds. The parking lights will flash once confirming

that the 1 Way this remote has been learned. The P2WSSR can recognize (1) 2 Way remote and (1) 1

Way remote.

1 2 3 4 5 6 7 8 9 10 ... 35 36

Sin comentarios

CompuSTAR 1W900SHR-961 Manual de instalación Pagina 5