CompuSTAR 1W900SHR-961 Manual de instalación descargar pdf (Pagina 19)

Pin 14 Yellow/Black - Engine sensing input. This wire is connected to the vehicles Tach or Alternator

wire and is required if you are not using the no tach sense setting. IMPORTANT: To change

engine-sensing modes, you must change Option 2-10; Default requires a Tach input.

Pin 15 White [POC 8]

- Horn honk 250mA negative (-) output. This is an optional output that will pulse

the factory horn. The proper wire will show ground (-) while the horn is sounding. To change horn

output settings, review Options 3-8 and 3-9.

Pin 16 Gray/Black

– Hood Pin negative (-) input. This input is a safety shut down and alarm trigger. It

prevents the vehicle from remote starting while the hood is open and triggers the alarm if the

hood is opened while the alarm is armed. You can connect this wire to the hood pin supplied with

this kit, or to a wire in the vehicle that shows (-) only while the hood is open.

Pin 17 Violet [POC 9]

- Dome light 250mA negative (-) output. This is an optional output that will provide

a 30 second (-) negative output after system is unlocked for dome-light supervision. To change

dome light output settings, review Option 3-2.

Pin 18 Brown

- Siren 12V positive (+) output. Connect this wire to the (+) wire located on the siren. To

change siren output settings, review Option 3-7.

Connector 4 (CN4), 6-Pin

Pin 1 Not used

Pin 2 Violet/White

- Trunk release 250mA negative (-) output. This is an optional output that will

release the trunk. Use CN1, Pin 2 if the vehicle is equipped with a (+) trunk release. System will

unlock doors and disarm alarm prior to trunk release.

Pin 3 Orange/Black

- 2

Unlock 250mA negative (-) output. This is an optional output that will provide

a (-) pulse for driver’s priority door lock. IMPORTANT: You must isolate the driver’s door and

turn on Option 1-3.

Pin 4 Blue

- Unlock 250mA negative (-) output. This is an optional output that will provide a (-) pulse for

unlocking doors. System will unlock doors and disarm alarm. IMPORTANT: You must reverse

polarity for (+) trigger door lock systems. For additional lock settings review Option Group

1 (page 31).

Pin 5 Blue/Black

- Lock 250mA (-) negative output. This is an optional output that will provide a (-)

pulse for locking doors. System will lock doors and arm alarm. IMPORTANT: You must reverse

polarity for (+) trigger door lock systems. For additional lock settings review Option Group

1 (page 31).

Pin 6 Not used

Connector 5 (CN5), 2-Pin (Pre-wired LED)

Note: Do not mistake for Thermistor port.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Comentarios a estos manuales

Sin comentarios

CompuSTAR 1W900SHR-961 Manual de instalación Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos CompuSTAR 1W900SHR-961