CompuSTAR 1W900SHR-961 Manual de instalación descargar pdf (Pagina 10)

STEP 3: Exit the vehicle and close the door. The vehicle’s engine should shut off upon closing the door.

If the vehicle’s engine does not shut off, check the door trigger connection or wait for the factory dome-

light to go out. The Firstech system is in reservation mode and the vehicle is ready to safely remote start.

Additional Notes

Reservation mode will be cancelle

d if the control module recognizes the vehicles door, hood or trunk

opening – or if the alarm is triggered. Each time the end user wants to remote start their manual

transmission vehicle, they must set the control module in reservation mode. Reservation mode settings

can be programmed with Option 1-06.

Version Diagnostics

All the new control modules come with the ability to check which firmware is on the module. This is

accomplished by turning the ignition on. Then with 2 Way remotes you must hold buttons 1 and 4

together for 2.5 seconds. With the 1 Way remotes you must hold the Lock and Key/Start buttons together

for 2.5 seconds. Current versions of CM4 Series V.37 and CM5 Series V.4 will flash 5 times when

attempting Version Diagnostics.

ADS Blade Cartridge Slot and Connector

This is the main feature of the new CM5000 and CM5200. The slot gives you the ability to use the Blade-

AL and Blade-TB modules from Firstech and ADS. With these modules you can virtually eliminate all

wire connections between your control module and bypass module. You only need to connect the main

ignition harness and your needed wires on the 20 pin Blade connector. For more information on how to

program and wire the Blade please visit www.idatalink.com/compustar

for the specific wiring diagram for

that vehicle.

Blade system includes:

1. Blade-AL or Blade-TB (NOTE: These modules are blank and must be flashed on your computer.)

2. 20 Pin wiring harness

3. 3 Pin harness used in some installs

IMPORTANT: Install diagrams are not included and must be downloaded from

www.idatalink.com/compustar

. When flashing the Blade you can use the Y-Cable OP500 end and not

CM4 Series end. ADS and Firstech recommends using the 4 pin RS232 cable to avoid confusion.

Cartridge must be removed to flash the control module firmware.

NOTE: The ADS-RNG C1, ADS-RNG C2, and ADS-RNG GM3 are not included and must be purchased

separately. The 20 pin Blade connector comes only with the Blade cartridge and not the CM5 control

modules.

WARNING: Manufacturer or seller will have no responsibility for any injuries and/or damages caused by

improper care of the product such as decomposition, conversion, and transform done by a user

voluntarily. WARNING: There should be no wiring routed around any pedals which

can cause a driving hazard.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Sin comentarios

CompuSTAR 1W900SHR-961 Manual de instalación Pagina 10