CompuSTAR CM4200DX Guía de instalación descargar pdf (Pagina 6)

Pin 7 *White/Black - 2nd Accessory 250mA (-) negative output. This is an optional output that will provide a (-)

negative output while the accessory output is triggered.

Pin 8 Red/White - Door trigger input. This wire monitors (-) negative or (+) positive trigger door-pins. The proper

wire will provide a (-) negative trigger or a (+) positive trigger only when the doors are opened. You will need

to test the wire for proper polarity and set door dip switch on the control module for the proper polarity. (Note:

This wire is required for manual transmission remote starts.)

Pin 9 *Black - Status 250mA (-) negative output. This is an optional output that will provide a (-) negative output

before the ignition is triggered, during remote start and will shut down after ignition has shut down. (Note: This

wire can be used to trigger factory security and remote start interface modules.)

Pin 10 Brown/White - This is a dual purpose wire that can be programmed in the options menu (Option 4-9) to

monitor the glow plug wire or the key sense wire.

Glow plug - This wire will show a (-) negative or (+) positive trigger while the wait to start light is on. This

wire will delay the starter output to allow the glow plugs to warm up on diesel engine vehicles.

Key sense - This wire will show a (-) negative or (+) positive trigger only when the key is physically in the

ignition. This will prevent the system from setting reservation (manual transmission) or accidental locking

and/or arming if the key is in the ignition. You will need to test the wire for proper polarity and set key/glow

jumper on the control module for the proper polarity.

Pin 11 *Orange - Factory alarm re-arm 250mA (-) negative output. This is an optional output that will provide a (-)

negative pulse output during lock, after crank and after ignition shut down.

Pin 12 Dark Orange - Slave/Timer start (-) negative input. This wire will activate remote start when provided a (-)

negative input. (Note: If vehicle is remotely started, a (-) negative input will turn the vehicle off.)

Pin 13 *Orange/White - Factory alarm disarm 250mA (-) negative output. This is an optional output that will provide

a (-) negative pulse output during unlock and before ignition is turned on.

Pin 14 Yellow/Black - Engine sensing input. A tach input or alternator input is required for the system to sense when

the vehicle is running. (Note: Input signal is selectable thru the option table. No connection is necessary for

voltage sensing.)

Pin 15 *White

- Horn honk 250mA (-) negative output. This is an optional output that will provide a 30 or 60 second

(-) negative pulse when the alarm is triggered or during panic.

Pin 16 Gray/Black - Hood-pin (-) negative input. This input is a safety shut down that will prevent the vehicle from

remote starting and shut down the engine when the hood is opened. (Note: This wire will also trigger the

alarm when the system is armed.)

Pin 17 *Violet - Dome light 250mA (-) negative output. This is an optional output that will provide a 30 second (-)

negative output after system is unlocked for dome-light supervision.

Pin 18 Brown

- Siren 12-volt (+) positive output. This wire will provide a 30, 60, 120 seconds or 10 pulse for 20

seconds (+) positive output for the external siren. (Note: Factory default is 30 seconds.)

CONNECTOR 4 (CN4)

Pin 1 Not used

Pin 2 Violet/White - Trunk release 250mA (-) negative output. This wire provides a (-) negative trigger pulse. (Note:

Positive trigger trunk release will require a relay. System will unlock doors and disarm alarm prior to

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Sin comentarios

CompuSTAR CM4200DX Guía de instalación Pagina 6