CompuSTAR 1WAMR-762 Guía de instalación descargar pdf (Pagina 6)

E. Option Programming for Six Button Remotes

The procedures will be the same as the 4 button remotes except the use of the different buttons.

Programming 6 Button Remote 4 Button Remote

Programming Menu 1 (Trunk+Start)- (I+II)-

Programming Menu 2 (Trunk+Stop)- (I+IV)-

Option Selection (Stop)- (IV)

Factory Setting Lock (I )

Option Selection Unlock (II )

Default Setting Selection (Start)- (III)

F. Programming Menu Options

Programming Menu #1 (Auto-Start and Door Lock Options)

Feature Factory Default Setting –

Button I

Optional Setting – Button II

1-1 Unlock Before, Lock After Starting,

Lock after remote start

OFF ON

1-2 Door Lock / Unlock Pulse Duration 0.8 sec 2.5 sec

1-3 Min. Crank Time for the Alternator

Sensing

0.8 sec 1.0 sec

1-4 Driver’s Priority Unlock OFF ON

1-5 Double Pulse Unlock OFF ON

1-6

N/A

1-7 Turbo OFF ON

Note

1-1 Some vehicles such as Mercedes-Benz and the Lexus ES300 require you to unlock the car to disarm the factory alarm before remote starting the

vehicle. Activating this feature will unlock the vehicle for a brief second in order to disarm the factory alarm before auto-starting the vehicle remotely then

lock after starting.

1-4 This feature unlocks the driver’s side door lock with the first unlock pulse. A second unlock pulse is needed to unlock the rest of the car doors.

Important! In order for this feature to operate, the installer must use the 2

Unlock Wire (Or/Bk wire of Connector 4). Isolate the driver’s door motor from

the rest of the other doors. Call us for technical support if you are not sure about this.

1-7 Turbo mode requires the connection of the emergency brake wire for either automatic or manual transmission vehicles. With this mode, engine will

continue running for two minutes after key is turned off if the emergency brake was set before the key was turned off and the foot brake was not being

pressed when the key was turned off.

Programming Menu #2 (Security Options)

Feature Factory Default Setting –

Button I

Optional Setting – Button II

2-1 Cold Start with Temp Sensor OFF ON

2-2 Timer Start or Minimum Interval

between Cold Starts

3 Hr 1.5 Hr

2-3 N/A

2-4 N/A

2-5 Ignition Controlled Door Lock OFF ON

2-6 N/A

2-7 N/A

2-8 N/A

1 2 3 4 5 6 7

Comentarios a estos manuales

bob 19 Nov 2024 | 00:39:09

753a

CompuSTAR 1WAMR-762 Guía de instalación Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos CompuSTAR 1WAMR-762